McIDAS-X uses shared memory for frame allocation. On some operating systems, the shared memory facility is activated by default and has a sufficient maximum segment size for most McIDAS-X sessions. However, this is not always true for Solaris, Linux and Mac OS X systems. The system administrator must check and, if necessary, force the kernel to activate the shared memory system at boot time and set the maximum segment size to 512 MB or greater the first time McIDAS-X is installed on a Solaris, Linux or Mac OS X workstation.
The McIDAS Users' Group uses the following settings on Solaris, Linux, and Mac OS X.
Solarisforceload: sys/shmsys |
2. Check the maximum size of a shared memory segment using the command below. The value is indicated in bytes; the example lists a 512 MB maximum shared memory segment.
If your value is less than 512 MB, go to step 3. If your value is 512 MB or greater, go to step 4.
3. Set the shared memory size to 512 MB or more by adding a line similar to the one below to the appropriate location in the file /etc/system.
set shmsys:shminfo_shmmax = 536870912 |
4. Reboot the system so the forceload entry and new maximum shared memory size take effect.
Check for lines similar to the two below. If the lines do not exist then add them to the end of the file. If the lines exist and are set to the value below (536870912) or greater you can leave them as is. If the lines exist but are set to a smaller value, change the values to those below.
kernel.shmmax = 536870912 kernel.shmall = 536870912 |
Run the following command from the Unix prompt.
kern.sysv.shmmax=536870912 kern.sysv.shmmin=1 kern.sysv.shmmni=128 kern.sysv.shmseg=32 kern.sysv.shmall=131072 |
After making these changes, the system will need to be rebooted for the changes to take effect.
Updated September 2016