McIDAS-X Learning Guide
Version 2020
[Search Manual]
[Table of Contents]
[Go to Previous]
[Go to Next]
Loop Control System
Table of Contents:
Loop Control System
The loop control system is a group of McIDAS commands for viewing image frames in a sequence. The order of frames in a loop can be sequential or random. For example, when image frames are loaded with a chronological series of satellite images, you can loop them to follow cloud motions. This lesson describes how to:
- create a loop
- change the dwell rate
- change the loop sequence
- add image frames to your McIDAS session
The following commands are used in this lesson.
| Command |
Function |
|
|
| A |
advances one frame |
| B |
backs up one frame |
| DR |
defines the dwell rate |
| F |
displays the workstation state |
| L |
turns looping on and off |
| LB |
sets frame loop bounds |
| LS |
defines a looping sequence |
| MAKFRM |
adds new frames to a McIDAS session |
| O |
displays the opposite frame |
[Search Manual]
[Table of Contents]
[Go to Previous]
[Go to Next]